Walk into any steel yard and you will hear GI, GP, HR and HR PO used in the same breath. They are not interchangeable. Each is made differently, protected differently and suited to different jobs. Knowing the difference helps you avoid paying for a coating you do not need, or buying bare steel for a job that will rust in a season.
Hot rolled (HR) steel is rolled at high temperature, which leaves a dark, slightly rough surface called mill scale. It is strong, economical and easy to weld and fabricate, so it is widely used for structural fabrication, tubes, frames and general engineering. It has no protective coating, so it needs paint or another finish when used outdoors.
HR PO coil is hot rolled steel that has been cleaned in an acid bath to remove the mill scale and then lightly oiled to prevent rust in storage. The cleaner surface takes paint and further coating better and is easier to form, so it suits parts that will be bent, pressed or painted.
GI stands for galvanised iron: steel coated with a layer of zinc. The zinc shields the steel from moisture and corrodes first, which gives long life in outdoor and humid conditions. GP stands for galvanised plain and usually refers to flat galvanised sheet, as opposed to corrugated sheet. In everyday trade the two names are often used loosely, so always confirm the coating and finish on your order.
GI and GP are common in roofing, cladding, ducting, enclosures and as the base material for pipes and profiles.
| Type | Surface | Corrosion protection | Common uses |
|---|---|---|---|
| HR black | Dark mill scale | None, needs paint | Structural fabrication, frames |
| HR PO | Clean and oiled | Light oil film only | Forming, pressing, painting |
| GI / GP | Zinc coated | Zinc coating | Roofing, ducting, cladding, pipes |
Shriuma Steel supplies HR black, HR PO, GI and GP coils and sheets. Browse our HR Coil and Sheet page and our GP and GI Coil and Sheet page, or send us your requirement for a quote.